Frigidaire Refrigerator Water Actuator Arm 241685703

• THIS FRIGIDAIRE 241685703 WATER ACTUATOR WORKS WITH MANY FRIGIDAIRE, ELECTROLUX AND KENMORE
• REFRIGERATORS
• Works with the following models: Frigidaire FLSC238DB4, Frigidaire FLSC238DS8
• Frigidaire FLSC238JS0, Frigidaire FLSC238JS1, Frigidaire FLSC238JS2, Frigidaire FRS6L9EFSS4

This is a substitute replacement for my Kenmore refrigerator actuator arm. Sears price was $87, but I got it from Amazon for $40. It fit perfectly and I received it in about three days from ordering. I dreaded installing it because it looked like I would have to tear into the water dispenser. My concern, what if I dismantled the dispenser, couldn't put it back together and then had to call Sears?! So, I gave it a try.

I removed the drip tray but there were no screws at the bottom of the module cover like the instructions indicated. I had to carefully pry out the bottom of the cover, then push down from the top and the cover popped off, no problem. One issue, the cover was still attached to the dispenser module by a ribbon cord. I couldn't figure out how to detach it so I left it on. The cover just dangled while unscrewed the three screws at the top of the module. I carefully wiggled out the module and pulled out the water tube. Then the module pulled out further so I could work on it.

I detached the red/black wire plug and had to cut it because it ran behind a little box. I unscrewed two small screws holding the broken actuator arm side prongs and then removed the broken arm. There was a spring arm that I had to make sure was in front of the actuator arm front prong. It allows the actuator arm to spring back so it's not constantly turning on the water. It was an easy thing to do.

Placing the water tube back in the water tube hole in the dispenser seemed impossible. I struggled with it for awhile then realized it would naturally go back into place as I screwed the module back on the refrigerator. It turned out to be simple once I realized the tube would just go back in place. I checked the water dispenser hole once I put in all the screws and I could see the tube was good to go.

The entire job was easy. It probably took me longer than most folks because I was very cautious and fooled around with the water tube way too long before figuring it out.

Easy job, saved me hundreds by doing it myself. To have a repairman come to the house would have been $100 just for the person to get to the house. Then if anything needed to be done, that would have been lots more.

Buy Frigidaire Refrigerator Water Actuator Arm 241685703 Now

This was an exact replica of the actuator arm I got quotes from Sears and other appliance stores nearby at more than double the amount. It did take me about an hr to figure out how to remove a few things around to install it but once I did, it felt good knowing I saved about $250 which is what some appliance techs wanted to charge me.

Read Best Reviews of Frigidaire Refrigerator Water Actuator Arm 241685703 Here

fits perfectly. found instructions for repair on youtube. it took about 20 minutes start to end to fix the dispenser

Want Frigidaire Refrigerator Water Actuator Arm 241685703 Discount?

Quick shipping and perfect fit. Unfortunately, the fridge install was a bit more complicated than initially thought but the part was perfect and everything works just fine.

This item is super tricky to install. I'm slightly above average when it comes to home improvements. Found a you tube video that make it pretty simple. Just a lot of steps and probably took me 1 hour from start to finish.