Home / House Drinking Water Filtration System - Cartridges made in the USA by KX Technologies

I purchased this unit mainly because the housing is made by 3M. But since installing it, I am even more impressed at the quality of water that comes out of the faucet. To make it a plus, the filters are reasonably priced and last over 6 months. The water pressure that comes out of this unit is great.

I am a very picky person and looked for months for a filter I was not sure at first due to low reviews but looked at the company online liked it usa made and .5 Micron filter is very good. This is a very easy intalation shark bite fittings and a adaptor to fit on your flex line under sink no tools needed I would also like to note the sink fauset threds is metal! Not plastic like most are that snap off when tightened this is a good qwality filter and it filters well and replacements filter are well priced

Buy Home / House Drinking Water Filtration System - Cartridges made in the USA by KX Technologies Now

I have a refrigerator water filter. This one works better than that one and aides in filling all my pots, coffee machine and other fresh water needed areas in the home. The water is now drinkable.

Read Best Reviews of Home / House Drinking Water Filtration System - Cartridges made in the USA by KX Technologies Here

I am basing my rating on the fact I have had experience with the filters with this unit. They are some of the best. Also,the unit itself is very well constructed. I have not yet installed it as it came with no parts sheet, no instructions, and I'm not a plumber so I have had to contact the seller direct. While cordial and responding usually about 24 hours later (send a question during the day and sometime the next day get an answer), I still am not a plumber and some of their responses and hand written out diagram won't really help me. I currently have a different unit that is an RO unit and I'm replacing it with this water filter (not an RO). The fittings I have under my sink now will have to be removed (one plugged and I hope I have the drain cap plug for it) and then replaced with new parts sent in with the unit. This weekend I will bite the bullet and remove the old and install the new. I hope I won't end up with either a leak from the removal and re-install of the new unit. I'm sure this would be a 45 minute or less job for a plumber, but for a novice I suspect it will take a few hours.

Want Home / House Drinking Water Filtration System - Cartridges made in the USA by KX Technologies Discount?