- Part Number: RIM300
- Quantity of 1
Buy Supco SUPCO RIM300 ICEMAKER REPLACEMENT KIT Now
The installation is very easy. If you are replacing an existing unit, just two screws to remove the old unit out and install the new one in. Watch the connector, it plugs just one way in, there is some kind of notch or guide.But instructions with the unit are very poor. It doesn't mention that one of the cables to plug have some kind of temperature sensor that needs to fit into a clip on the underside of the unit.
Without that part fitted there, the unit may not work. !!!!!!!!!!
And again the instructions didn't cover that.
On the other hand, one good thing, you can adjust the amount of water that goes in to make the ice cubes.
It came with all the parts needed, including a mounting plate that helps fit the unit to older refrigerators where the mounting screws maybe at a different location.
Read Best Reviews of Supco SUPCO RIM300 ICEMAKER REPLACEMENT KIT Here
I paid a little more for this than other after market icemakers I looked at, due to me seeing the connections were the exact same as the one I had. Glad I did. Installed in 7 min. Took several cycles of ice to fine tune how much water the unit uses. Started out only making 5 cubes per cycle, now makes 7. Can make 8 but not for me???? Turned the fill adjustment screw as high as it goes. Still, 7 more cubes than my old one made....Want Supco SUPCO RIM300 ICEMAKER REPLACEMENT KIT Discount?
This is more about the supplier than the Ice Maker. After about 6 months, I began to have some unusual problems with the ice maker. I contacted this supplier to inquire about what I might do to remedy the problems. Without asking, they offered to replace the unit and shipped a new ice maker to me without charge. The replacement is now installed and running without problems.I would do 6 stars for the vendor if I could!!!Pulled out the old and this was cheesy easy to install, works like a champ.
The Supco RIM300 is a bargain.
No comments:
Post a Comment